Archer C8 AC1750 Wireless Dual Band Gigabit Router
Chapter 2. Connecting the router
2.1System Requirements
Broadband Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the router is connected directly to the Ethernet)
PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors
TCP/IP protocol on each PC
Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari
2.2Installation Environment Requirements
Place the router in a
Avoid direct irradiation of any strong light (such as sunlight)
Keep at least 2 inches (5 cm) of clear space around the router
Operating Temperature: 0℃~40℃ (32℉~104℉)
Operating Humidity: 10%~90%RH,
2.3Connecting the router
Before installing the router, make sure your PC is connected to the Internet through the broadband service successfully. If there is any problem, please contact your ISP. After that, please install the router according to the following steps. Don't forget to pull out the power plug and keep your hands dry.
1.Power off your modem (if the modem has a backup battery, please remove it too.), and disconnect your existing router if you have one.
2.Connect the Internet port on your Router to the Modem’s LAN port with an Ethernet cable.
3.Connect your computer to one of the Ethernet ports labeled 1~4 on the Router with an Ethernet cable.
4.Power on the modem and wait for 2 minutes.
5.Make sure the Wireless On/Off switch is ON. Then plug the provided power adapter into the Power jack and the other end to a standard electrical wall socket. Press the On/Off button to power on the Router. (Before you power on the Router, please make sure your computer is NOT connected to any other wireless network.)
- 7 -