TP-Link AC1750 manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1） This device may not cause harmful interference.

2） This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement:

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

Image 3

Contents Archer C8 Copyright & Trademarks FCC Statement 5150-5250 MHz Country Restriction Reason/remark Country Restriction Reason/remark5470-5725 MHz Country Restriction Reason/remark 5250-5350 MHz Country Restriction Reason/remarkKorea Warning Statements Safety Information Yang Hongliang Product Manager of International Business Product Description AC1750 Wireless Dual Band Gigabit RouterContents Dhcp 100 Package Contents Conventions Overview of the routerMain Features Panel Layout Front PanelName Status Indication Rear Panel  RESET/WPSArcher C8 AC1750 Wireless Dual Band Gigabit Router Installation Environment Requirements Connecting the routerSystem Requirements Hardware Installation Archer C8 Quick SetupDynamic IP WAN Connection TypePPPoE/Russian PPPoE Static IPL2TP Pptp Archer C8 AC1750 Wireless Dual Band Gigabit Router Internet Network MapArcher C8 AC1750 Wireless Dual Band Gigabit Router  Note Archer C8 AC1750 Wireless Dual Band Gigabit Router Archer C8 AC1750 Wireless Dual Band Gigabit Router Wireless USB SettingsFile Sharing Select Start Run  Sharing Settings Sharing Mode Print Server Guest NetworkArcher C8 AC1750 Wireless Dual Band Gigabit Router Status Advanced1 WAN Network Note Archer C8 AC1750 Wireless Dual Band Gigabit Router Archer C8 AC1750 Wireless Dual Band Gigabit Router Archer C8 AC1750 Wireless Dual Band Gigabit Router Archer C8 AC1750 Wireless Dual Band Gigabit Router Archer C8 AC1750 Wireless Dual Band Gigabit Router Archer C8 AC1750 Wireless Dual Band Gigabit Router MAC Clone 3 LAN Wireless 2.4GHz Wireless SettingsDual Band Selection Archer C8 AC1750 Wireless Dual Band Gigabit Router 2 WPS II. Enter the client device’s PIN on the router Use the Wi-Fi Protected Setup ButtonWireless Security Archer C8 AC1750 Wireless Dual Band Gigabit Router  Encryption You can select either Automatic, or Tkip or AES AC1750 Wireless Dual Band Gigabit Router 22 Add or Modify Wireless MAC Address Filtering entry Wireless MAC FilteringTo modify or delete an existing entry Wireless Advanced Wireless Statistics Wireless 5GHz Test 2 WPS Wireless Security Archer C8 AC1750 Wireless Dual Band Gigabit Router  Encryption You can select either Automatic, or Tkip or AES AC1750 Wireless Dual Band Gigabit Router 35 Add or Modify Wireless MAC Address Filtering entry To modify or delete an existing entry Wireless Advanced Wireless Statistics  Access And Bandwidth Control 38 Guest Network Wireless SettingsDhcp  Wireless 5GHzDhcp Settings Address Reservation Dhcp Clients List43 Add or Modify an Address Reservation Entry To Reserve an IP addressDevice Settings  Sharing Account 46 File Sharing47 Add or Modify Share Folder NAT Boost 48 Pint Server SettingVirtual Servers Forwarding52 Add or Modify a Virtual Server Entry To setup a virtual server entryTo add a new rule, follow the steps below Port TriggeringArcher C8 AC1750 Wireless Dual Band Gigabit Router Once the router is configured, the operation is as follows 10.3 DMZTo assign a computer or server to be a DMZ server UPnP Basic Security SecurityAdvanced Security  Note 60 Local Management Local ManagementRemote Management To add a new entry, please follow the steps below Parental ControlArcher C8 AC1750 Wireless Dual Band Gigabit Router Access Control Rule There are two methods to add a new rule Method One Archer C8 AC1750 Wireless Dual Band Gigabit Router Archer C8 AC1750 Wireless Dual Band Gigabit Router Method Two 70 Add Internet Access Control EntryHost Archer C8 AC1750 Wireless Dual Band Gigabit Router Target Schedule To add a new schedule, follow the steps below Advanced Routing Other configurations for the entries Static Routing ListTo add static routing entries System Routing Table Bandwidth ControlRules List Control Settings16 IP & MAC Binding Binding SettingsTo find an existing entry, follow the steps below To add IP & MAC Binding entries, follow the steps belowARP List To set up for DDNS, follow these instructions Dynamic DNSComexe.cn Ddns Dyndns.org Ddns 18 IPv6 Support DHCPv6 Server 18.1 IPv6 Status18.2 IPv6 Setup DHCPv6 Slaac Static IPv6 PPPoEv6  Get IPv6 Address Way Tunnel 6to4 System Tools To set time manually Time SettingsDiagnostic To set time automaticallyTo set Daylight Saving Archer C8 AC1750 Wireless Dual Band Gigabit Router 106 Diagnostic Results Firmware UpgradeBackup & Restore Factory DefaultsReboot System Log PasswordArcher C8 AC1750 Wireless Dual Band Gigabit Router Statistics Archer C8 AC1750 Wireless Dual Band Gigabit Router Total Modify ResetStatistics Table IP/MAC Address PacketsAppendix a FAQ Want to use Netmeeting, what do I need to do? Figure A-3 MAC CloneFigure A-5 Add or Modify a Virtual server Entry Want to build a WEB Server on the LAN, what should I do? Figure A-7 Basic SecurityFigure A-9 Virtual Servers Wireless stations cannot connect to the routerInstall TCP/IP component Appendix B Configuring the PCVerify the network connection between your PC and the router Please check the connection following these steps Figure B-5 Failure result of Ping commandWireless GeneralEnvironmental and Physical Appendix D Glossary Archer C8 AC1750 Wireless Dual Band Gigabit Router

Related manuals

Manual 2 pages 19.3 Kb

Manual 146 pages 25.44 Kb