ZyXEL Communications 100 manual Problems With the Configuration, Troubleshooting the Configuration

ZyAIR 100 Wireless PC Card

5.2Problems With the Configuration

Table 5-2 Troubleshooting the Configuration

PROBLEM	CORRECTIVE ACTION
Problems encountered with	Use the utility Loopback Test to check the link status with the Access
the configuration.	Point it is associated with (Infrastructure mode).
	Use the utility Master – Slave Test to check the link status between the
	ZyAIR 100s (Ad-hocmode).
	Use the utility Site Survey to check whether there is high interference
	around the environment.
	Ensure that you have set the correct IP address for the ZyAIR 100. Use
	the Ping command to ping the unit itself.
	If Netbeui is installed and relevant parameters are set properly, you can
	go to the Network Neighborhood found on your Windows® desktop to
	check if you can see your PC.

5.3Problems With the Settings for the Access Point

Table 5-3 Troubleshooting the Settings for the Access Point

PROBLEM	CORRECTIVE ACTION
Problems with settings for	Make sure that the Access Point is powered on and all the LEDs are
the Access Point.	working properly.
	Use the Ping command to ping any other host. If the host does not
	respond, your Access Point might not be connected to the network.
	Re-configure and reset the Access Point.
	Use the Web Manager/Telnet of the Access Point to check whether all the
	Access Points are connected to the network.

5-2 Troubleshooting