ZyXEL Communications A-6000 manual Command list, Details

A-6000 High Speed, Long Range Ethernet Wireless Bridge

Chapter 4 CLI commands

4.1 command list

How to use CLI commands to get or set system information , frequency, and other different parameters, following pages give you detailed information for each command.

Use CLI commands to display the current system configuration, you may also set the system parameters to configure your system. Contents of the CLI commands are listed as below:.

(1)To display/modify the function of auto channel selection

(2)To display system configuration

(3)To display/modify frequency radio channel

(4)To display/modify gateway IP address

(5)To display hardware

(6)To display platform hardware version

(7)To display/modify IP address

(8)To display/modify IP subnet mask

(9)To display security policy

(10)To modify security policy

(11)Security Key Configuration

(12)System Configuration

(13)To display/modify login user name

(14)To modify login password

(15)To display/modify power

(16)To display/modify data rate

(17)To display/modify SNTP Server

(18)To display station status

(19)To display/modify SSID

(20)To display/modify SSID Suppress

(21)To display/modify System Name

(22)To display/modify Telnet

(23)To display/modify Time Zone

(24)To display elapsed time

(25)To display time and date

(26)To display software version

4.2Details

(1)To display/modify the function of auto channel selection

Use the get/set autochannelselect command to get status or set functions of the auto channel selection. Examples are shown as below:

-> get autochannelselect Auto Channel Select: Enabled

-> set autochannelselect disabled Auto Channel Select: Disabled

-> set autochannelselect enabled Auto Channel Select: Enabled

(2)To display system configuration

Use the get config command to display the system configuration. For example:

-> get config

(3)To display/modify frequency radio channel

Use the get/set frequency command to display or modify the radio channel. For example:

-> get frequency

Radio Frequency: 5250 MHz (IEEE 50) -> set frequency 5250

Radio Frequency: 5250 MHz (IEEE 50)

(4)To display/modify gateway IP address

Use the get/set gateway command to display or modify the gateway IP address.

CLI commands 4-1