ZyXEL Communications A-6000 manual Mounting bracket, The Mounting kit Network/Power Injector

A-6000 High Speed, Long Range Ethernet Wireless Bridge

7.Mounting bracket

The mounting kit is used to provide a good support for the outdoor unit and the flat panel antenna. Please follow the installation procedure to mount the outdoor unit and the flat panel antenna. The contents of the mounting kit are shown below.

Figure 2-10 The Mounting kit

8.Network/Power Injector

The network /power injector is used to combine the data stream and power into one cable. It has three ports. The port named POWER is for 15V power from the switching power adapter. The port named TO LAN is connected the customer premises equipment (CPE) by Cat-5 cable. The port named TO RADIO is connected to the outdoor unit by the cable described in item 5.

The appearance of the network/power injector is shown below.

Figure 2-10Network/Power Injector

9.Antenna Alignment Kit

Two flat panel antennas of the A-6000 should be well aligned before the normal operation. If the antenna alignment is not well done, the received signal strength will be small and the link quality will be not good enough to support high-speed data communication. The antenna alignment kit is connected to the outdoor unit through the RS-232 cable. You should modify the vertical and horizontal angle of the panel antenna according to the signal strength indicated on the AK-100. The outward appearance of the antenna alignment is shown below.

Figure 2-11Antenna Alignment Kit (AK-100)

Hardware Installation 2-4