(16)To display/modify data rate
Use the get/set rate command to display or modify the data rate. Select one of the following data rates: 6, 9, 12, 18, 24, 36, 48, 54, and best, respectively. The first 8 data rates are fixed rates and the last one is a variable rate. When choosing the best rate, the BU attempts to deliver unicast data packets at the highest possible optimum data rate. If there are obstacles or interference, the BU automatically steps down to an optimum data rate that allows for reliable data transmission. In addition, the optimum data rate is adjusted periodically by the BU, based on past performance of the data transmissions at different neighboring data rates.
(17)To display/modify SNTP Server
Use the get sntpserver command to display or modify the SNTP/NTP server IP address.
SNTP/NTP Server IP address:
(18)To display station status
Use the get station command to display station information and status.
MacAddr: 00:03:7f:00:00:01, State: associated, AID: 1
Authentication Type: Open System
Encryption: ON, slot 4 shared[1] 40b key: aabbccddee
Power Save Mode: OFF
Rx Data Rate: 36, RxSignalStrength: 46, AckSignalStrength: 45 MSDU Data Mcast Mgmt Ctrl Errors
Rx 70 68 68 2 0 0
Tx 227 225 0 2 0 0
(19)To display/modify SSID
Use the get/set ssid command to display or modify the SSID. The SSID is a text string of up to 32 characters in length. Control characters are not allowed.
SSID: ZyXEL 802.11a Wireless Network
(20)To display/modify SSID Suppress
Use the get/set ssidsuppress command to display or modify the SSID suppress mode. When enable, the SSID in beacons are not transmitted and only STAs with knowledge of an BU’s SSID are able to associate with the BU.
SSID Suppress Mode: Disabled
(21)To display/modify System Name
Use the get/set systemname command to display or modify the basestation unit system name. The system name is the name of the basestation unit, and is a text string of up to 32 characters in length. Control characters are not allowed.
CLI commands |