Kramer Electronics user manual FC-1ETHN Configuration Manager Window Functionality

Using the Kramer Configuration Manager Software

Table 3: FC-1ETHN Configuration Manager Window Functionality

#	Feature	Function
1	Device List	Displays the MAC Addresses for the FC-1ETHN devices, connected via the selected
		port (LAN or COM).
2	Master Mode	When selected, activates the Master mode (see section 6.3.2).
	Check Box	When cleared, activates the Slave mode (see section 6.3.1).
3	DHCP1	When selected, automatically configures the FC-1ETHN to obtain an IP address from
	Mode Check	the network administrator via the Dynamic Host Configuration Protocol (DHCP)
	Box	When cleared, manual configuration of the FC-1ETHN is required to obtain an IP
		address (Static IP)
4	Network	IP Address: A 32-binary digit number obtained
	Settings	from your Network Administrator that identifies the
		FC-1ETHN device that is currently being		For example:
		configured in the Ethernet or Internet.
		Subnet: A 32-binary digit number obtained from
		your Network Administrator, which combined with
		the IP Address, identifies which network your
		FC-1ETHN device is on.
		Gateway: A network position serving as an entry
		to another network or to the Internet (only relevant
		in the Master Routing mode).
		Local Port is an address of the FC-1ETHN device
		that is currently being configured that provides a
		direct route from another Ethernet point application.
5	Destination	Destin. IP A 32-binary digit number that identifies		For example:
	Device	the destination FC-1ETHN device in the Ethernet
	Settings	or Internet.
		Port is a pre-assigned address of the destination
		FC-1ETHN device that provides a direct route to
		its Transport layer.
6	Serial	In the serial setting speed list, click the appropriate	baud speed2 (1200, 2400, 4800,
	Setting	9600, 19200, 38400, 57600, 115200).
7	Action	Search: seeks the FC-1ETHN devices that connect to the PC via the chosen LAN or
	Buttons	COM port, and displays them and their corresponding settings.
		Setting: adjusts the FC-1ETHN according to the displayed data.
8	Progress Bar	Shows the progress
9	Status Bar	Shows the status
10	Exit Button	Closes the Configuration Manager application
11	Version	Displays the firmware version number
12	Menu bar	File menu’s Exit command closes the Configuration Manager application.
		Action menu’s Search Board command seeks the FC-1ETHN devices that connect to
		the PC via the chosen LAN or COM port, and displays them and their corresponding
		settings.
		Action menu’s Setting command adjusts the FC-1ETHN according to the displayed
		data.
		Port menu displays the Choose Port window.
		Set MAC1 menu is for factory use only (click the Password command to enter the
		password).

1 See definition in Table 1

2 The configuration baud is factory preset, and fixed, at 9600

6 KRAMER ELECTRONICS, LTD.