KTI Networks KS-220F/S-5 Making Network Connections, Two Switched Ports, Configuration Switches

Page 10

3. Making Network Connections

On rear panel, Port 1 and Port 2 have individual configuration switches as shown below:

Port 1, Port 2	SW1	Off	Auto-negotiation is enabled.
		On	Auto-negotiation is disabled.
Port 1, Port 2	SW2	Off	100Mbps is used. (When SW1 = On)
		On	10Mbps is used. (When SW1 = On)
Port 1, Port 2	SW3	Off	Full-duplex is used. (When SW1 = On)
		On	Half-duplex is used. (When SW1 = On)
Port 2 only	SW4	Off	Fiber connector is disabled.
		On	Fiber connector is enabled.

Image 10

Contents Installation Guide 10/100 Bridging ConverterPage Trademarks Interpreting LED Indicators Table of Contents IntroductionInstallation Making Network ConnectionsIntroduction Features Standard SpecificationsConnectors Port 1 2 RJ-45 jacks FX LED for PortInstallation guide Unit One AC power adapter for the switch InstallationInstallation UnpackingChecking AC Power Two switched ports are located on the front panel Two Switched PortsConfiguration Switches Factory DefaultsJack Function TP PortsImportant Note Pin assignments of the jacks are defined as followsCompliant UTP Cables Connected Device SW1 setting Port Operation ModeUTP Connections Connection UTP Cable Type Maximum LengthFiber Cables Required fiber cable for the connection are Fiber Port and Fiber ConnectionModel Series Applications Following table lists some applications using the deviceConnecting to Duplex type Maximum length Connected device Duplex type Maximum lengthInterpreting LED Indicators Following figure shows the locations of the LED indicators