KTI Networks KS-220F/S-3, KS-220F/S-A, KS-220F/C Fiber Port and Fiber Connection, Model Series

Page 13

Fiber Port and Fiber Connection

When connecting to a 100BASE-FX device using fiber cable, make sure Port 2 SW4 is set to ON position and TX-to-RX connection rule is followed.

Since the fiber connector does not support auto-negotiation func- tion, it is recommended to set SW1 to ON position for the fiber connection. If SW1 is set to OFF, it operates on half-duplex mode.

Fiber Cables

The required fiber cable for the connection are:

Model

/T model

/C model

/S series

Fiber mode

Multimode

Multimode

Single mode

Wavelength

1300∝ m

1300∝ m

1300∝ m

Connectors

ST

SC

SC

Multimode fiber: 50/125, 62.5/125, 85/125, 100/140∝ m

Single mode fiber: 9/125∝ m

The maximum distance connecting to a 100BASE-FX device de- pends on the device connected and the duplex mode used for the connection as follows:

-9-

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 10/100 Bridging Converter Installation GuidePage Trademarks Installation Table of Contents IntroductionInterpreting LED Indicators Making Network ConnectionsIntroduction Features Connectors Port 1 2 RJ-45 jacks SpecificationsStandard FX LED for PortInstallation InstallationInstallation guide Unit One AC power adapter for the switch UnpackingChecking AC Power Configuration Switches Two Switched PortsTwo switched ports are located on the front panel Factory DefaultsImportant Note TP PortsJack Function Pin assignments of the jacks are defined as followsUTP Connections Connected Device SW1 setting Port Operation ModeCompliant UTP Cables Connection UTP Cable Type Maximum LengthFiber Cables Required fiber cable for the connection are Fiber Port and Fiber ConnectionModel Series Connecting to Duplex type Maximum length Following table lists some applications using the deviceApplications Connected device Duplex type Maximum lengthFollowing figure shows the locations of the LED indicators Interpreting LED Indicators
Top Page Image Contents