KTI Networks KS-220F/S-A, KS-220F/S-3, KS-220F/C, KS-220F/S-5 UTP Connections, Compliant UTP Cables

Page 12

UTP Connections

The following figure shows a UTP connection from TP port to another device via a straight-through UTP cable. When TP port of Port 2 is used, make sure Port 2 SW4 is set to OFF position.

Depending on the configuration switch setting, the operating modes used for connecting to different devices are shown as follows:

Connected Device	SW1 setting Port Operation Mode
10M Ethernet hub	AUTO	10BASE-T, half-duplex
100M Fast Ethernet hub	AUTO	100BASE-TX, half-duplex
10/100M dual speed hub	AUTO	100BASE-TX, half-duplex
10/100M NWay switch	AUTO	100BASE-TX, full-duplex
10/100M NWay NIC card	AUTO	100BASE-TX, full-duplex
10M Ethernet device	Non-auto	10BASE-T, half-duplex

* Note that all hub devices are half-duplex devices.

Compliant UTP Cables

Connection	UTP Cable Type	Maximum Length
10BASE-T	Cat. 3, 4, or 5	100 meters
100BASE-TX	Cat. 5	100 meters

When using a straight-through cable for the connection, make sure the MDI-X to MDI connection rule is followed.

-8-

Image 12

Contents Installation Guide 10/100 Bridging ConverterPage Trademarks Table of Contents Introduction InstallationInterpreting LED Indicators Making Network ConnectionsIntroduction Features Specifications Connectors Port 1 2 RJ-45 jacksStandard FX LED for PortInstallation InstallationInstallation guide Unit One AC power adapter for the switch UnpackingChecking AC Power Two Switched Ports Configuration SwitchesTwo switched ports are located on the front panel Factory DefaultsTP Ports Important NoteJack Function Pin assignments of the jacks are defined as followsConnected Device SW1 setting Port Operation Mode UTP ConnectionsCompliant UTP Cables Connection UTP Cable Type Maximum LengthFiber Port and Fiber Connection Fiber Cables Required fiber cable for the connection areModel Series Following table lists some applications using the device Connecting to Duplex type Maximum lengthApplications Connected device Duplex type Maximum lengthInterpreting LED Indicators Following figure shows the locations of the LED indicators