KTI Networks KS-801 manual Duplex Mode Setting, Specifications

Page 19

Duplex Mode Setting

The duplex mode used for the fiber module is configured by software port control settings. See chapter 5 for more information.

Specifications

Standard	IEEE 802.3u 100BASE-FX
Speed	100Mbps
Duplex mode	Full duplex or half duplex
Wavelength	1300nm
Fiber Connectors	ST, SC, MT-RJ, VF-45
Fiber cable	MM 50/125mm, 62.5/125mm recommended
	SM 9/125mm recommended

Module Installation

1.Turn off the power to the switch unit.

2.Open the cover of Fiber slot.

3.Set Fiber jumper J1.

4.Insert the module into slot until it is seated properly.

5. Screw the module onto the chassis securely.

-19-

Image 19

Contents KS-801 Installation GuideInternational Fax 886-2-26983873 Mail Kti@ktinet.com.tw Installation Guide Port Fast Ethernet Managed Switch with Fiber ConnectivityTrademarks Table of Contents Introduction Features Page Specifications Packing List Installing the SwitchPanels Fiber Slot 100M Fiber slot for Port #9 LED indicatorsMounting the Switches Making Network Connections Network Switched Ports10/100BASE-TX Fast Ethernet Switched Ports Manual Configuration Switch can support connections to the following devices10/100BASE-TX Fast Ethernet Ports Straight-through and Crossover UTP Cable Fast Ethernet Fiber Slot Module Connector type Fiber cable Maximum lengthPage Specifications Duplex Mode SettingMaking Trunk Connections Switch supports the following trunk configurationsPage Making Sniffer LED Panels LED IndicatorsInterpretation Management Support Performing Network ManagementManagement objects Login Port StatusConsole Management Setting IP AddressConsole interface consists of a series of menu list Telnet Management Web ManagementConsole port does not support modem connection Snmp Management Upgrade FirmwareSupport