IOGear M0557 manual Creating a Mirrored-Striped Set RAID, Select Create RAID set. Press F2

Page 16

Creating a Mirrored-Striped Set (RAID 10)

1.As the BIOS boots, press CTRL+S or F4 to enter the RAID bios utility.

2.Select Create RAID set. Press F2.

3.Select RAID 10 then press Enter.

4.Select Auto configuration. Press Enter.

5.Press Y and then press ESC to exit the setup.

7.Continue with conventional Fdisk and Format steps to prepare the hard drives.

8.Your RAID hardware configuration is complete. Proceed to software installation section.

Creating Parity RAID (RAID 5)

1.As the BIOS boots, Press CTRL+S or F4 to enter the RAID bios utility.

2.Select Create RAID set. Press Enter.

3.Select RAID 5 then press Enter.

4.Select Auto configuration. Press Enter.

5.Press Y to save your settings.

16

Image 16
Contents Installation Guide Page Table of Contents Page Page Introduction Features Package Contents What Is RAID? RAID Redundant Array of Independent DisksDisk Striping RAID Disk Mirroring RAIDMirrored-Striping RAID 0+1 also known as RAID Parity RAID RAIDJust a Bunch of Disks JBOD/Contiguous Installation Procedure Use the SATARAID5 Manager GUI to configure your RAID settings Bios RAID Settings Creating Striped Sets RAIDSelect Create RAID set. Press Enter Select the Number of hard drives. Press EnterCreating Mirrored Sets RAID Select Auto configuration. Press EnterSelect Create RAID set. Press F2 Creating a Mirrored-Striped Set RAIDCreating Parity RAID RAID Creating Spare Drive Creating Jbod SetsSelect Spare Drives. Press Enter Select Delete RAID set. Press Enter Deleting RAID SetsRebuilding Mirrored Sets RAID Software Installation Windows XP Fresh InstallationWindows XP Existing Installation Page Verifying Controller Installation Federal Communications Commission FCC Statement Page CE Statement Limited Warranty Contact Toll Free 866 9-IOGEAR Phone 949 453-8782 23 HubbleFUN