IOGear M0557, GICe702S3R5W6 manual Windows XP Existing Installation

Page 20

Windows XP Existing Installation

1.Power off the system. Insert the controller card into a PCI slot and connect the hard drives to the controller card. Power up the system.

2.During OS boot up, Windows will display the ‘Found New Hardware Wizard’. Click ‘Next’.

3.Select ‘Install from a list or speciﬁc location (Advanced)’ and Click ‘Next’.

20

Image 20

Contents Installation Guide Page Table of Contents Page Page Introduction Features Package Contents What Is RAID? RAID Redundant Array of Independent DisksDisk Striping RAID Disk Mirroring RAIDMirrored-Striping RAID 0+1 also known as RAID Parity RAID RAIDJust a Bunch of Disks JBOD/Contiguous Installation Procedure Use the SATARAID5 Manager GUI to conﬁgure your RAID settings Bios RAID Settings Creating Striped Sets RAIDSelect Create RAID set. Press Enter Select the Number of hard drives. Press EnterCreating Mirrored Sets RAID Select Auto conﬁguration. Press EnterCreating Parity RAID RAID Creating a Mirrored-Striped Set RAIDSelect Create RAID set. Press F2 Select Spare Drives. Press Enter Creating Jbod SetsCreating Spare Drive Rebuilding Mirrored Sets RAID Deleting RAID SetsSelect Delete RAID set. Press Enter Software Installation Windows XP Fresh InstallationWindows XP Existing Installation Page Verifying Controller Installation Federal Communications Commission FCC Statement Page CE Statement Limited Warranty Contact Toll Free 866 9-IOGEAR Phone 949 453-8782 23 HubbleFUN