IOGear GICe702S3R5W6, M0557 Creating Mirrored Sets RAID, Select Auto conﬁguration. Press Enter

Page 15

5.Select RAID size. Press Enter.

6.Press Y to save your settings.

7.Press CTRL+E and then press Y to exit the setup.

8.Continue with conventional Fdisk and Format steps to prepare the hard drives.

9.Your RAID hardware conﬁguration is complete. Proceed to software installation section.

Creating Mirrored Sets (RAID 1)

1.As the BIOS boots, Press CTRL+S or F4 to enter the RAID bios utility.

2.Select Create RAID set. Press Enter.

3.Select RAID 1 then press Enter.

4.Select Auto conﬁguration. Press Enter.

5.Press Y to save your settings.

6.Press CTRL+E and then press Y to exit the setup.

7.Continue with conventional Fdisk and Format steps to prepare the hard drives.

8.Your RAID hardware conﬁguration is complete. Proceed to software installation section.

15

Image 15

Contents Installation Guide Page Table of Contents Page Page Introduction Features Package Contents Disk Mirroring RAID What Is RAID?RAID Redundant Array of Independent Disks Disk Striping RAIDParity RAID RAID Mirrored-Striping RAID 0+1 also known as RAIDJust a Bunch of Disks JBOD/Contiguous Installation Procedure Use the SATARAID5 Manager GUI to conﬁgure your RAID settings Select the Number of hard drives. Press Enter Bios RAID SettingsCreating Striped Sets RAID Select Create RAID set. Press EnterSelect Auto conﬁguration. Press Enter Creating Mirrored Sets RAIDCreating a Mirrored-Striped Set RAID Select Create RAID set. Press F2Creating Parity RAID RAID Creating Jbod Sets Creating Spare DriveSelect Spare Drives. Press Enter Deleting RAID Sets Select Delete RAID set. Press EnterRebuilding Mirrored Sets RAID Windows XP Fresh Installation Software InstallationWindows XP Existing Installation Page Verifying Controller Installation Federal Communications Commission FCC Statement Page CE Statement Limited Warranty Toll Free 866 9-IOGEAR Phone 949 453-8782 23 Hubble ContactFUN