KTI Networks KF223TX, KF230TX manual LED Indicators, Interpretations

Page 22

5. LED Indicators

Each Fast Ethernet adapter has three LEDs, as shown in Figure 1-1.

5.1 Interpretations

The interpretations of the LEDs are:

100Mb LED indicates an active 100Mbps connection is established.

On : Good connection between adapter and 100BASE-TX hub

Off : No connection between adapter and hub

Blink: Not applicable

10Mb LED indicates an active 10 Mbps connection is established.

On : Good connection between adapter and 10BASE-T hub

Off : No connection between adapter and hub

Blink : Not applicable

Activity LED indicates packets are being received or transmitted.

Blink : Network traffic is present

On : Not applicable

Off : No traffic for either speed

If you experience any problems, first make sure that the appropriate driver is loaded, the proper cable is connected to the connector, and the hub complies with the adapter specifications (10 Mbps 10BASE- T or 100 Mbps 100BASE-TX). Then recheck the LED.

17

Image 22
Contents Installation Guide 10/100 Dual-speed Fast Ethernet PCI AdaptersUnited States InternationalTrademarks Fast Ethernet PCI Adapters Installation Guide Figures Adapter Features IntroductionConnector and LEDs Network Connector and LEDsInstalling the Adapter Installing the AdapterConnecting to the Network Inserting the Adapter into the PCI SlotConnecting 10BASE-T Cable Mbps ConnectionConnecting 100BASE-TX Cable Network Driver Installation Driver InformationPCI Bios Setup Setup Program Running Setup ProgramBefore running the program Starting the Setup Program Asetup enterInstall NetWare DOS ODI driver Running Install MenuFunctions on the Main Menu Running Setup Menu Setup MenuRunning Diagnostics Menu Diagnostics MenuPage Page LED Indicators InterpretationsA1. Specifications AppendixA2. RJ-45 Connector & Cables Pin Signal NameAn auto-negotiation device Duplex mode half-duplex or full-duplexAuto-negotiation Function Non-auto-negotiation deviceDiagnostics Report Installing Remote Boot ROM