KTI Networks KF230TX, KF223TX manual Trademarks

Page 3

TRADEMARKS

Ethernet is a registered trademark of Xerox Corp. NetWare is a registered trademark of Novell Inc.

WARNING:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference in which case the user will be required to correct the interference at his own expense.

NOTICE:

(1)The changes or modifications not expressively approved by the party responsible for compliance could void the user's authority to operate the equipment.

(2)Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits.

CISPR A COMPLIANCE:

This device complies with EMC directive of the European Community and meets or exceeds the following technical standard.

EN 55022 - Limits and Methods of Measurement of Radio Interference Characteris- tics of Information Technology Equipment. This device complies with CISPR Class A.

WARNING: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

CE NOTICE

Marking by the symbol CE indicates compliance of this equipment to the EMC directive of the European Community. Such marking is indicative that this equip- ment meets or exceeds the following technical standards:

EN 55022: Limits and Methods of Measurement of Radio Interference characteris- tics of Information Technology Equipment.

EN 50082/1:Generic Immunity Standard -Part 1: Domestic Commercial and Light Indus- try.

Image 3
Contents 10/100 Dual-speed Fast Ethernet PCI Adapters Installation GuideInternational United StatesTrademarks Fast Ethernet PCI Adapters Installation Guide Figures Introduction Adapter FeaturesNetwork Connector and LEDs Connector and LEDsInstalling the Adapter Installing the AdapterInserting the Adapter into the PCI Slot Connecting to the NetworkMbps Connection Connecting 10BASE-T CableConnecting 100BASE-TX Cable Driver Information Network Driver InstallationPCI Bios Setup Running Setup Program Setup ProgramBefore running the program Asetup enter Starting the Setup ProgramRunning Install Menu Install NetWare DOS ODI driverFunctions on the Main Menu Setup Menu Running Setup MenuDiagnostics Menu Running Diagnostics MenuPage Page Interpretations LED IndicatorsAppendix A1. SpecificationsPin Signal Name A2. RJ-45 Connector & CablesNon-auto-negotiation device Duplex mode half-duplex or full-duplexAuto-negotiation Function An auto-negotiation deviceDiagnostics Report Installing Remote Boot ROM