Peavey JSX 212 manual Important Safety Instructions

Page 3

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using electrical products, basic cautions should always be followed, including the following:

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus.

11.Only use attachments/accessories provided by the manufacturer.

12.Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a

cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Never break off the ground pin. Write for our free booklet “Shock Hazard and Grounding.” Connect only to a power supply of the type marked on the unit adjacent to the power supply cord.

16.If this product is to be mounted in an equipment rack, rear support should be provided.

17.Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug‚ proceed as follows:

a)The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E‚ the earth symbol‚ colored green or colored green and yellow.

b)The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black.

c)The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red.

18.This electrical apparatus should not be exposed to dripping or splashing and care should be taken not to place objects containing liquids, such as vases, upon the apparatus.

19.Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in suscep- tibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level exposures:

Duration Per Day In Hours

Sound Level dBA, Slow Response

8

90

6

92

4

95

3

97

2

100

1 1⁄2

102

1

105

1⁄2

110

1⁄4 or less

115

According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors to the ear canals or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss, if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation.

SAVE THESE INSTRUCTIONS!

3

Image 3
Contents JSX 212Joe Satriani Signature All-Tube Amplifier Page Important Safety Instructions Bewahren SIE Diese Sicherheitshinweise AUF Gardez CES Instructions Guarde Estas Instrucciones English O N T PA N E L Noise Gate VolumeFAT Switch TrebleChannel Select Switch High Gain InputLOW Gain Input A R PA N E L Speaker Outputs Cabinet Impedance SwitchHIGH/LOW Power Switch Ground Polarity SwitchDomestic AC Mains Cord IEC Mains ConnectorULTRA/CRUNCH Selector Cable ConnectorClean Selector O T S W I T C HJSX 212 Block Diagram JSX212 Español PA N E L F R O N TA L Graves VolumenAgudos MediosEntrada DE Ganancia Alta Entrada DE Ganancia BajaInterruptor DE Selección DE Canal PA N E L T R a S E R O Salida DE Linea Interruptor DE Impedancia ImpedanciaSalidas DE Altavoces Nivel DE Salida DE LineaCable DE Corriente Domestico EN Eeuu Conector Principal IECSelector Ultra / Crunch Selector CleanD a L Conector DE CableJSX 212 Diagrama en Bloque JSX Français Lampe DE Statut PA N N E a U AVA N TSelecteur D’ALIMENTATION Selecteur DE Circuit DE Chauffe StandbyLeds D’INDICATION DE Canal Actif MediumsSelecteur DE Canal 23/24 Boucle D’EFFETS Effects Send / Effects Return Remote Switch PedalierPA N N E a U a R R I È R E Controle DE Niveau D’ENVOI D’EFFETS Effects Send LevelSortie Ligne Line OUT Selecteur D’IMPEDANCE D’ENCEINTESorties HAUTS-PARLEURS Controle DE Sortie Ligne Line LevelConnecteur IEC Selecteur Ultra / Crunch Selecteur DE Canal Clair CleanD a L I E R Connecteur Cable DINJSX 212 Diagrama en Bloque Section Amplificateur DE Puissance Deutsch Standby PowerPOWER-ANZEIGE R D E R S E I T EFAT-SCHALTER HIGH-GAIN-EINGANG LOW-GAIN-EINGANGCHANNEL-SCHALTER EFFECTS-RETURN-PEGEL C K S E I T EEFFECTS-SEND-PEGEL 23/24 Effects Send / Effects ReturnGround Polarity Cabinet ImpedanceHIGH/LOW-LEISTUNGSSCHALTER Fuse NetzsicherungHinweis NUR FÜR Grossbritannien IEC-NETZSTECKERULTRA/CRUNCH-WAHLSCHALTER CLEAN-WAHLSCHALTERS S S C H a LT E R Remote CableJSX 212 Block Diagram Technische Daten Peavey Electronics Corporation Limited Warranty 80304951