Peavey JSX 212 manual O N T Pa N E L

F R O N T PA N E L

6 5 2 1

7 4 3

(1)	POWER SWITCH	WARNING
	This two-way toggle switch applies mains power to the
		THE ON/OFF SWITCH IN THIS APPARATUS
	unit. The red POWER STATUS LAMP (3) will illuminate
		DOES NOT BREAK BOTH SIDES OF THE MAINS.
	when this switch is in the ON position.	HAZARDOUS ENERGY MAY BE PRESENT INSIDE
		THE ENCLOSURE WHEN THE POWER SWITCH IS
		IN THE OFF POSITION.

(2)STANDBY SWITCH

This two-way toggle switch allows the amp to be placed in STANDBY mode. In the STANDBY position the tubes stay hot but the amplifier is not operational. Switching to the ON position places the amp in active mode.

(3)POWER STATUS LAMP

This indicator illuminates when mains power is being supplied to the amp.

(4)PRESENCE

This is used to fine-tune the high frequency range of the speaker enclosure by varying the damping factor of the amplifier at high frequencies.

(5)RESONANCE

This is used to fine-tune the low frequency range of the speaker enclosure by varying the damping factor of the amplifier at low frequencies.

(6)MASTER VOLUME

This control sets the overall volume level of the amp. Once the desired balance between the three channels in the amplifier has been achieved, the entire output level of the unit can be increased or decreased by rotating this control. Clockwise rotation increases the level; counterclockwise rotation decreases the level.

(7)MASTER REVERB

This controls the overall reverb level.

8