Kramer Electronics Configuring the FC-8 Wi-Fi RS-232 Bridge, Connecting the FC-8 to a Network

Page 10

Configuring the FC-8 Wi-Fi - RS-232 Bridge

Figure 3: Connecting the FC-8 Wi-Fi - RS-232 Bridge (Access Point)

5.2Connecting the FC-8 to a Network

The FC-8is connected to the network by software configuration as described in Section 6 .

6Configuring the FC-8 Wi-Fi - RS-232 Bridge

This section explains how to configure the FC-8and the host system for operation. The section includes:

Using the Default Network Configuration, see section 6 .1

Configuring the Host System, see section 6 .2

Changing the FC-8Configuration, see section 6 .3

Configuring an Active Station, see section 6 .4

6	KRAMER: SIMPLE CREATIVE TECHNOLOGY

Image 10

Contents Model Page Contents TablesPage Introduction Getting StartedQuick Start Your FC-8 Wi-Fi RS-232 Bridge OverviewYour FC-8 Wi-Fi RS-232 Bridge Connecting the FC-8 Wi-Fi RS-232 Bridge Connecting the Controlled Device to the FC-8Configuring the FC-8 Wi-Fi RS-232 Bridge Connecting the FC-8 to a NetworkUsing the Default Network Configuration Configuring the Host System to Operate with FC-8Changing the FC-8 Configuration Wireless Network Connection WindowSerial Net Configuration Screen of the FC-8 FC-8 Serial Net Configuration Parameters Baud Rate Settings Configuring an Active Station Operating the FC-8Technical Specifications FC-8technical specifications are shown in TablePage 2900-000358 REV