Kramer Electronics FC-8 user manual Baud Rate Settings

Configuring the FC-8 Wi-Fi - RS-232 Bridge

Parameter			Possible Values			Notes
Wireless LAN WEP Key1		WEP64 ± no more than 10
		characters (5 bytes) allowed
		(hex 0-9 A-F)
		WEP128 ± no more than 26
		characters (13 bytes)allowed
		(hex 0-9 A-F)
Wireless LAN WEP Key2		Same as WEP Key1
Wireless LAN WEP Key3		Same as WEP Key1
Wireless LAN WEP Key4		Same as WEP Key1
Pre-shared Key Passphrase		WPA ± ASCII string must be
		between 8-63 alphameric
		characters
SerialNet Serial Parameters		<b, d, p, s, f >			Where:
		5, 8, N, 1, 0 (Default)			b = baud [1±9 or h] (see Table 4)
					d = data bits [7 or 8]
					p = parity [N, E, O]
					s = stop bits [1]
					f = flow [0, 1]
Default IP		192.168.3.2			Factory default address
		Set to 0.0.0.0 to receive IP
		address from a DHCP server
[Submit]					Enters the changes made in the
					configuration table
[Refresh]					Redisplays values of the configuration
					screen
			Table 4: Baud Rate Settings
	Baud Code		Baud Rate	Baud Code		Baud Rate
	1		600	6		19200
	2		1200	7		38400
	3		2400	8		57600
	4		4800	9		115200
	5		9600	h		230400

2.Change the parameters as needed to attach the FC-8to the new network and press Submit.

Important: When changing the IP address, input the same new address into both the Active IP Address field and in Default IP field.

Note: It may take a few minutes for the update to complete.

Warning: You must enter the correct network parameters. If the parameters are incorrect, the network will not recognize the unit and you will not be able to access the device until it is reconfigured using a special program1, which can be downloaded from the Kramer Web site.

1 The FC-8must be connected to a PC over the serial port while running the program

11