Kramer Electronics user manual Serial Net Configuration Screen of the FC-8

Page 13

Configuring the FC-8 Wi-Fi - RS-232 Bridge

To change the FC-8configuration, do the following:

1.In the Internet browser of a PC attached to the FC-8network, enter the IP address of the FC-8(for example, using the default IP address: 192.168.3.2).

The Serial Net setup page appears (see Figure 5). Table 3 explains the fields.

Figure 5: Serial Net Configuration Screen of the FC-8

Image 13

Contents Model Page Tables ContentsPage Getting Started IntroductionQuick Start Overview Your FC-8 Wi-Fi RS-232 BridgeYour FC-8 Wi-Fi RS-232 Bridge Connecting the Controlled Device to the FC-8 Connecting the FC-8 Wi-Fi RS-232 BridgeConnecting the FC-8 to a Network Configuring the FC-8 Wi-Fi RS-232 BridgeConfiguring the Host System to Operate with FC-8 Using the Default Network ConfigurationWireless Network Connection Window Changing the FC-8 ConfigurationSerial Net Configuration Screen of the FC-8 FC-8 Serial Net Configuration Parameters Baud Rate Settings Operating the FC-8 Configuring an Active StationFC-8technical specifications are shown in Table Technical SpecificationsPage 2900-000358 REV