IOGear M1023 user manual Connecting to a USB device in Vista

Page 43

Connecting to a USB device in Vista

1.After you have successfully installed the USB Net ShareStation driver, connect the USB device to the USB Net ShareStation and make sure both the USB device and the USB Net ShareStation are powered on.

2.When the USB device is connected, the USB Net ShareStation will detect the connection of the device, and an icon of the device will show up in the Network window. In this example, we have connected a Logitech USB speaker.

Image 43

Contents Installation Guide Page Table of Contents Introduction About this Manual Package Contents How it works Hardware Installation Ethernet Cable Ethernet Cabl e Software Installation XP/2K Page Page Page Page Page Page Select Finish to complete the Found New Hardware Wizard Page Connecting to a USB device Page Page Connecting to a USB Printer / Multifunction Printer Page Page Connecting to a USB hub Page Disconnecting a USB device Request to Disconnect Page Page Software Installation Vista Click OK to start the installation process Page Click on Finish to complete the installation process Page Page Page Page Page Page Page Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Page Connecting to a USB hub in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Polling Interval Setting the Polling Interval Widows -XPPage Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Page FAQ Federal Communications Commission FCC Statement Page CE Statement Limited Warranty IOGEAR, INC ContactPage FUN