IOGear M1023 user manual Setting the Polling Interval Widows -XP

Page 51

Setting the Polling Interval Widows -XP

The polling interval will allow the conﬁguration utility to pull information from your network to ﬁnd out the status of all the connected USB Net ShareStations and USB devices. By default, this feature is not automatically conﬁgured. You may set a time so that the server will perform the polling automatically. To conﬁgure the polling interval, in the IOGEAR USB Server utility, click on File -> Settings ->

Polling Interval.

Image 51

Contents Installation Guide Page Table of Contents Introduction About this Manual Package Contents How it works Hardware Installation Ethernet Cable Ethernet Cabl e Software Installation XP/2K Page Page Page Page Page Page Select Finish to complete the Found New Hardware Wizard Page Connecting to a USB device Page Page Connecting to a USB Printer / Multifunction Printer Page Page Connecting to a USB hub Page Disconnecting a USB device Request to Disconnect Page Page Software Installation Vista Click OK to start the installation process Page Click on Finish to complete the installation process Page Page Page Page Page Page Page Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Page Connecting to a USB hub in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Polling Interval Setting the Polling Interval Widows -XPPage Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Page FAQ Federal Communications Commission FCC Statement Page CE Statement Limited Warranty IOGEAR, INC ContactPage FUN