IOGear M1023 user manual Connecting to a USB hub

Page 26

Connecting to a USB hub

1.If you have more than one USB device that you would like to share over your network, you may add a USB 2.0 hub (4-port maximum) to the USB Net ShareStation.

Connect the USB cable of the USB hub to the USB port on the IOGEAR USB Net ShareStation, then connect the USB device(s) to the USB ports on the USB hub. Make sure the power adapter of the USB hub is plugged in and powered on.

Image 26

Contents Installation Guide Page Table of Contents Introduction About this Manual Package Contents How it works Hardware Installation Ethernet Cable Ethernet Cabl e Software Installation XP/2K Page Page Page Page Page Page Select Finish to complete the Found New Hardware Wizard Page Connecting to a USB device Page Page Connecting to a USB Printer / Multifunction Printer Page Page Connecting to a USB hub Page Disconnecting a USB device Request to Disconnect Page Page Software Installation Vista Click OK to start the installation process Page Click on Finish to complete the installation process Page Page Page Page Page Page Page Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Page Connecting to a USB hub in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Setting the Polling Interval Widows -XP Polling IntervalPage Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Page FAQ Federal Communications Commission FCC Statement Page CE Statement Limited Warranty Contact IOGEAR, INCPage FUN