IOGear M1023 user manual Request to Disconnect

Page 29

Request to Disconnect

1. If a USB device is being used by another computer on your network, a red icon will be displayed in front of the device name. You will not have the option to disconnect the device, however, you may send a courtesy message to request that the other user disconnect/release the device.

29

Image 29
Contents Installation Guide Page Table of Contents Introduction About this Manual Package Contents How it works Hardware Installation Ethernet Cable Ethernet Cabl e Software Installation XP/2K Page Page Page Page Page Page Select Finish to complete the Found New Hardware Wizard Page Connecting to a USB device Page Page Connecting to a USB Printer / Multifunction Printer Page Page Connecting to a USB hub Page Disconnecting a USB device Request to Disconnect Page Page Software Installation Vista Click OK to start the installation process Page Click on Finish to complete the installation process Page Page Page Page Page Page Page Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Page Connecting to a USB hub in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Polling Interval Setting the Polling Interval Widows -XPPage Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Page FAQ Federal Communications Commission FCC Statement Page CE Statement Limited Warranty IOGEAR, INC ContactPage FUN