IOGear M1023 user manual

Page 50

NOTE: after a system reboot, you might not be able to connect to any USB device for a short period of time. When right clicking on a device, you will see the following message instead of the option to “Connect.”

Depending on the performance of your PC and the number of active USB Net ShareStations on your network, it may take up to 3 minutes for your computer to recognize all USB Net ShareStation. This is because VISTA needs time to probe the entire network before it loads the necessary driver to run the USB Net ShareStation. Once the driver has been loaded, the option to “Connect” to the device will be made available when right-clicking a device.

50

Image 50
Contents Installation Guide Page Table of Contents Introduction About this Manual Package Contents How it works Hardware Installation Ethernet Cable Ethernet Cabl e Software Installation XP/2K Page Page Page Page Page Page Select Finish to complete the Found New Hardware Wizard Page Connecting to a USB device Page Page Connecting to a USB Printer / Multifunction Printer Page Page Connecting to a USB hub Page Disconnecting a USB device Request to Disconnect Page Page Software Installation Vista Click OK to start the installation process Page Click on Finish to complete the installation process Page Page Page Page Page Page Page Connecting to a USB device in Vista Page Connecting to a USB hard drive in Vista Page Connecting to a USB hub in Vista Disconnecting a USB device in Vista Request to Disconnect in Vista Page Setting the Polling Interval Widows -XP Polling IntervalPage Web Management Interface Page Page Page Upload Firmware Reset Device Factory Default Page FAQ Federal Communications Commission FCC Statement Page CE Statement Limited Warranty Contact IOGEAR, INCPage FUN