TV+ | MANUAL V1.0 | OTHER RECORDING FUNCTIONS > P. 70 |
-“Bitrate”: 500kb/s, 1000kb/s, 1500kb/s, 2000kb/s, 2500kb/s. Use this to set the encoding quality. The higher the encoding rate, the higher the image quality but also more hard drive space will be used.
-“Sampling”: 32kHz, 48kHz. This is the sound sampling rate. The higher value gives a higher quality sound but will take up more space on the hard drive.
-“Contrast”: adjusts the recorded image contrast.
-“Brightness” *: adjusts the recorded image brightness.
-“Saturation” *: use this to
-“Hue” *: changes the color spectrum in the recorded image.
-“RGB settings” *: “Automatic”/ “Manual”. Allows you to adjust the 3 RGB color levels (only when the source outputs an RGB signal).
-“Blue saturation” *: Adjusts the level of blue (only when the source outputs a component signal).
-“Red saturation” *: Adjusts the level of red (only when the source outputs a component signal).
-“Reset”: changes the above settings to the default values.
*These parameters will vary according to which type of signals are present on the TV+ inputs.
COPY PROTECTION
•The ARCHOS recording system is designed to respect the Macrovision™ copyright protection system. If the source of your video is
KPIRNC[DCEM KPFKECVKPIVJCVVJGÒNGYKNNDGCRTQVGEVGFÒNG
•2TQVGEVGFÒNGUECPQPN[DGRNC[GFDCEMQPVJG#4%*15VJCVETGCVGFVJGOCPF PQVQPCEQORWVGT6JGRNC[DCEMQHRTQVGEVGFÒNGUKUCNUQNKOKVGFVQVJG*&/+
HDCP video output (in this case, your TV must have an HDMI/HDCP input con- nector). It cannot be displayed on a television using any other video output type.
10.3RECORDING AUDIO MANUALLY
With the ARCHOS, you have the possibility to record audio from most
CP[UVCPFCTFCWFKQUQWTEG JKÒVWTPVCDNGDQQODQZGVE
RECORDING PROCEDURE
Connect your audio source’s outputs to the ARCHOS’ inputs.