Canon LV-7260, LV-7265, LV-X7 ❷ Making Connections, Digital Audio Analog IN-2 Analog IN-1

2. Installation and Connections

❷Making Connections

NOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby mode and before turning on the power to the notebook PC.

In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered up.

*If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power man- agement software.

Enabling the computer’s external display

Displaying an image on the notebook PC’s screen does not necessarily mean it outputs a signal to the projector. When using a PC compatible laptop, a combination of function keys will enable/disable the external display. Usually, the combination of the ‘Fn” key along with one of the 12 function keys gets the external display to come on or off. For more details, refer to your computer’s owner’s manual.

Connecting Your PC or Macintosh Computer (LV-7265)

NOTE: The ANALOG IN- 1 connector supports Plug & Play (DDC2).

DIGITAL IN/	AUDIO IN
ANALOG IN-2	ANALOG IN-1
	AUDIO IN ANALOG -1
L
S-VIDEO
IN	IN /
SERVICE PORT	IN-2OUT

VIDEO	R
IN
	AUDIO IN

Use the optional DVI digital cable (LV-CA29) to connect the DIGITAL IN/ANALOG IN-2 connector for a com- puter with DVI/DVI-I output.

DVI digital cable (Optional: LV-CA29)

PHONE

Audio cable (not supplied)

IBM PC or Compatibles (Desktop type) or Macintosh (Desktop type)

VGA cable (supplied)

To mini D-Sub 15-pin connector on the projector. It is recommended that you use a commercially available distribution amplifier if connecting a signal cable longer than the supplied one.

NOTE: For older Macintosh, use a commercially available pin adapter (not supplied) to connect to your Mac's video port.

PHONE

IBM VGA or Compatibles (Notebook type) or Macintosh (Notebook type)

NOTE: Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor turns down the sound.

NOTE: An image may not be displayed correctly when a Video or S-Video source is played back via a commercially available scan converter.

This is because the projector will process a video signal as a computer signal at the default setting. In that case, do the following.

*When an image is displayed with the lower and upper black portion of the screen or a dark image is not displayed correctly: Project an image to fi ll the screen and then press the AUTO PC button on the remote control or the projector cabinet.

15