3. Projecting an Image (Basic Operation)
❸Adjusting the Picture Size and Position
Place your projector on a fl at level surface and ensure that the projector is square to the screen.
Lift the front edge of the projector to center the image vertically.
• If the projected image does not appear square to the screen then use the Keystone feature for proper adjustment. See page 28 to 29.
Move the projector left to center the image horizontally on the screen.
Adjust the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjustment as it can become heated while the projector is turned on and during its cool down period after it is turned off.
2.Push and hold the adjustable tilt foot lock button on the front of the projector to extend the adjustable tilt foot.
1 | - |
2
3.Lower the front of the projector to the desired height.
4.Release the adjustable tilt foot lock button to lock the adjustable tilt foot.
There is approximately 10 degrees (up) of adjustment for the front of the projector.
5. The rear foot height can be adjusted up to 10 mm/0.4 inch.
Adjustable Tilt Foot Adjustable Tilt Foot Lock Button
3
Rotate the rear foot to the desired height in order to square the image on the projection surface, but the vertical distance from the bottom to the desk or fl oor should be 10 mm/0.4 inch to make the projector horizontal on the fl at surface.
4
NOTE: Rotating the rear foot too much may cause the foot to come out of the pro- jector.
CAUTION:
Do not use the
26
Up Down