![](/images/new-backgrounds/1107307/10730753x1.webp)
Basic Operations
5. Adjusting the Sound Volume
To increase the volume : press [VOLUME] ª (0 ➞ 50)
| To lower the volume | : press [VOLUME] · (50 ➞ 0) |
VOL. | VOLUME |
|
STAND BY
LAMP TEMP OPERATE
PCVIDEO
VOL. |
MENUEXIT
ENTER
5
Projector: | Remote |
Control panel | control unit |
12 |
When “Menu display” (☞ page 39) is set to “15sec”, after pressing the [VOLUME] button, the sound vol- ume display will appear on the screen for about 15 seconds.
(Press [EXIT] button to immedi- ately remove the
Audio-Vol 12 ![](/images/new-backgrounds/1107307/10730753xi3.webp)
![](/images/new-backgrounds/1107307/10730753xi4.webp)
OPERATE
PC VIDEO
W
| S |
| FREEZE |
VOLUME FOCUS | QUICK ALIGN. |
MENU | EXIT |
ENTER |
|
5
Screen display
Note
•When the sound volume is displayed on the screen, pressing the [PRESET] button will reset the set value to “0”.
6.Power Off
1 Press the [OPERATE] button on the projector (or the [OP-
ERATE] button on the remote control unit ) for 1 second or more
•The [OPERATE] indicator will disappear, the [STAND BY] in- dicator starts to blink, and the projector goes into the cool- down mode. The [STAND BY] indicator will continue blinking for approximately 90 seconds as the temperature of the light source lamp cools (Cool Down Mode).
PRESET | HIDE |
OPERATE
OPERATE
Projector: | Remote |
Control panel | control unit |
Turn off Blink
STAND BY
LAMP TEMP OPERATE
Projector: Indicator
Note
•The [OPERATE] button will not work for approximately 1 minute from when the
2Plug out the power cord from wall outlet
Caution
•Please do not pull out the plug from the power source when the [STAND BY] indicator is blinking. It will shorten the life of the lamp and cause a malfunction.
27