Dukane 28A8035 manual Use of batteries, When you are not going to use For a long time, Volume

Page 7
Pull out the power plug from the power outlet.

Caution

Use of batteries.

Do not use batteries not specified for this unit. Do not use new batteries mixed together with old ones. This may cause a fire, injury due to burst of battery, liquid leakage.

When inserting batteries in this unit, pay attention to the direction of the

and polarity indications and insert the batteries correctly. If the polarities are confused, it may cause injury or damage near the unit due to burst batteries, liquid leakage, etc.

Caution when replacing the lamp.

When replacing the lamp, turn off the power of the projector and disconnect the power plug from the power outlet. Then wait for

45 minutes to allow the lamp cool:

Failure to do so could result in a burn.

∙ For disposal of used lamp, treat according to the instruction of community authorities.

∙ Since the lamp is made of glass, do not apply shock to it and do not scratch it.

∙ Also, do not use old lamp. This could also cause

explosion of the lamp.

ENGLISH

When you are not going to use

for a long time.

When you are not going use this unit for a long time because you are going on a trip, etc., be sure to pull out the power plug from the power outlet for safety. And also apply cover to the lens so that the lens is not damaged.

Pull out the power plug from the power outlet.

∙ If it is probable that the lamp has exploded

(explosive sound is heard), disconnect the power

plug from the power outlet and ask your dealer

to replace lamp. The lamp is covered by front

glass and air-tight structure, but, in rare cases,

the reflector and the inside of the projector may

be damaged by scattered broken pieces of glass,

and broken pieces could cause injury when

being handled.

Clean inside the unit at least once two years.

Ask your dealer to clean inside the unit at least once two years. If the unit is left

with too much dust inside as it is for

a long this without cleaning, it may cause a fire. Especially it is effective

to clean before the rainy season

starts. Consult your dealer for the cost of the cleaning the inside the unit.

[General cautions]

∙ When the lamp has been replaced, reset the

accumulated operation time of the lamp.

Do not reset if the lamp has not been replaced.

Front glass

Reflector

Lamp

Do not place this unit where it gets hot.

Be careful since if you place the unit outdoors, in a place exposed to direct sunlight or near a heating device, the cabinet and parts could be affected.

Volume.

Use at the proper volume level so that it does not bother persons in the neighborhood. Especially, since the sound is likely to carry well at the night even at a low volume, consider the neighborhood to a good living environment.

Cleaning the lens.

To clean the lens, use a generally-available lens cleaning tissue (used for cleaning lens of camera, glasses, etc.). Be careful not to scratch the lens with a hard object.

Cleaning the cabinet.

Since many plastic materials are used on the surface of the cabinet, if the surface is cleaned using benzene, thinner, etc., it may change in quality or the coating may be peeled off. Avoid using chemicals.

When a chemically-teated cloth is used, follow the cautions that come with the cloth.

Do not spray a volatile agent such as insecticide on the unit. Do not leave a rubber or vinyl object touching the cabinet for a long time. It may cause the cabinet to change in quality or the coating to peel off.

Clean the dirt from the cabinet and operation panel by dusting lightly with a soft cloth. If the dirt is conspicuous, wipe off with a cloth moistened with detergent diluted with water, then wipe off with a dry soft cloth.

Rest your eyes occasionally when

viewing for a long time.

7

Image 7 Contents
28A8035 For the Customers in U.K Instructions to Users Video signal cablesPower cord Before useIf any abnormality occurs Do not look directly at the lens when Lamp is litDo not install this unit in an unstable place Do not use power supplies other Than that specifiedDo not stare directly into the laser aperture Be careful in handling the power cordClean inside the unit at least once two years CleaningHandle the power cord carefully Use of batteries When you are not going to use for aCleaning the lens When you are not going to use For a long timeDo not place this unit where it gets hot VolumeContents of shipping box RGB input terminal Remote control sensor Main Power switchAC in socket Video input terminalRemote control transmitter Names and functions of each part How to insert batteriesExample of the projector and screen installation InstallationHow to use foot adjusters To project the picture Basic operationsPress the STANDBY/ON button, for 1 second To turn off the powerFreeze Function To return to the initial setting Adjustments and functionsMemory function Manual Operation How to use the SET UP menuBar display items VOLUME, Bright etc Numerical display items V POSIT, H Posit etcAdjustment Item Details of adjustment AUTO-adjustmentAUTO-adjustment Confirm Screen During AUTO-adjustmentReveal Connection to the RGB signal terminal Connection to the video signal terminalsResolution Standard Display Dots KHz Type Example of computer signalComputer/signal Horizontal Timing µs Initial set signalsComputer/signal Vertical Timing lines Control signal terminal Connection to the control signal terminalMouse emulation ADB Mac mouse PS/2 mouseSerial mouse RS232C cable Reference Control command tableControl command table CommunicationCommand data Example of command error Procedure of getting the Projector statusProcedure of setting the Projector status Procedure of default setting the Projector statusComputerDesk type Example of system setupConnecting various equipment AC Inlet Computer Note typeAir filter Filter cover Cleaning the air filterRemove the lamp cover How to replace lampLoosen two screws and pull the handle to remove Lamp Reset the lamp time Install the lamp cover and fix it using screwsLamp Action Indicator displayMessage table On-screen displayWhen you think something wrong RCA Jack terminal Input terminal Input/Output Dimension diagramOperating guide RGB cable Legal Information Mail avsales@dukane.com St. Charles, IL Fax