Basic Operation
Turning Off the Projector
1 | Press the POWER button on the top control or on the |
|
|
|
|
| remote control unit, and a message "Power off?" appears on |
|
|
|
|
| the screen. |
|
|
|
|
2 | Press the POWER button again to turn off the projector. The |
|
|
|
|
|
|
|
| ||
POWER indicator starts to blink red, and it continues while |
|
|
|
| |
|
|
|
|
| |
| the cooling fans are operating for about 90 seconds. (About |
|
|
|
|
| 120 seconds when the fan mode is L2. See page 44.) |
|
|
|
|
|
|
|
|
|
|
|
| The message disappears after 4 seconds. | |||
3 | When the projector has cooled down enough to be turned on | ||||
| again, the POWER indicator emits red light. Then you can | ||||
disconnect the AC power cord.
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU
TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES
BEFORE TURNING IT OFF.
DO NOT DISCONNECT AC POWER CORD WHILE
COOLING FANS ARE RUNNING OR BEFORE THE
POWER INDICATOR EMITS RED LIGHT. OTHERWISE
IT WILL RESULT IN SHORTENING THE LAMP LIFE.
✔Note:
•The projector cannot be turned on during the cooling period with the POWER indicator blinking red. You can turn it on again after the POWER indicator emits red light.
•Do not operate the projector continuously without rest. Continuous use may result in shortening the lamp life. Turn off the projector and give it a rest about an hour in every 24 hours.
•This projector monitors internal temperature and automatically controls the running speed of the cooling fans.
•If the WARNING indicator blinks or emits red light, see “Warning Indicator” on page 45.
18