Canon LV-S4 manual Progressive, Film

Video Input

Progressive

Interlaced video signal can be displayed in a progressive picture.

Off . . . .Not activated.

L1 . . . . .Select “L1” for an active picture.

L2 . . . . .Select “L2” for a still picture.

Film

This function is effective on 3-2 pulldown video sources. With this function on, the projector reproduces pictures faithful to the original film quality.

Reset

To reset the adjusted data, select Reset and press the OK button.	Store icon
The confirmation box will appear and then select [Yes]. All
adjustments return to their previous figures.

Store

To store the image data adjusted manually, move the red frame pointer to the Store icon and press the OK button. The message “OK?” will appear. Select [Yes] to store the manual adjustment.

To set this manual adjustment, select Custom by pressing the IMAGE button or through the Image Select Menu (p34).

If you change the Image level (p34) without storing the adjusted data, the figures will go back to the factory default settings.

Quit

Close the Image Level Adjustment.

✔Note:

•Progressive cannot be selected when 480p, 575p, 720p, 1035i, or 1080i is selected. (p33)

•Film can only be activated when selecting NTSC for Video System and L1/ L2 for Progressive and in any state shown below.

1.When selecting NTSC, NTSC4.43 PAL-M or 480i in the Video System Selection (p33).

2.When selecting Auto and signal is NTSC, NTSC4.43, PAL-M(Composite) or 480i(Component) in the Video System Selection (p33).

•3-2 Pulldown or Telecine transfer is the process of changing images from film mode to video mode. While film runs at 24 frames per second (fps), NTSC television signals (or video) have a run rate of 30fps so the 24 fps film needs to be speeded up to 30fps and transferred using a proper field pattern to get the best film-like images.

“OK?” message

Move the pointer to [Yes] and then press the OK button.

36