Computer Input
Auto PC Adjustment
The Auto PC Adj. function is provided to automatically adjust Fine sync, Total dots, Horizontal, and Vertical to conform to your computer. The Auto PC Adj. function can be operated as follows.
Direct Operation
The Auto PC adjustment function can be operated directly by pressing the AUTO PC button on the remote control unit.
Remote Control Unit
KEYSTONE IMAGE NO SHOW
D.ZOOM FREEZE AUTO PC
AUTO PC button
MUTE
Menu Operation
PC Adjust Menu
| Auto PC Adj. |
1 | Press the MENU button to display the |
| Press the Point 7 8 buttons to move the red frame pointer |
| to PC Adjustment Menu icon. |
2 | Press the Point d button to move the red frame pointer to |
| Auto PC Adj. icon and then press the OK button twice. |
To store adjustment parameters
Adjustment parameters from Auto PC Adj. can be memorized in this projector. Once parameters are memorized, the setting can be done just by selecting Mode in the Computer System Menu (p25). See “Store” on page 28.
PC Adjust Menu icon
Move the red frame pointer to the Auto PC Adj. icon and press the OK button.
"Wait a moment!" message appears while Auto PC adjustment is in process.
✔Note:
•Fine sync, Total dots and Picture Position of some computers can not be fully adjusted with this Auto PC Adj. function. When the image is not provided properly with this operation, manual adjustments are required. (p27, 28)
•The Auto PC Adj. cannot be operated when 480i, 575i, 480p, 575p, 720p,1035i, or 1080i is selected in the Computer System Selection. (p25)
26