Delta Electronics LCP-10G3A4EDR manual Digital Diagnostic Monitoring Interface

LCP-10G3A4EDR

Digital Diagnostic Monitoring Interface

Alarm and Warning Thresholds (2-Wire Address A2h)

Address		#		Name	Value (Dec.)	Unit		Note
		Bytes
00-01	2			Temp High Alarm	85 degree Celsius	℃	1
02-03	2			Temp Low Alarm	-10 degree Celsius
04-05	2			Temp High Warning	80 degree Celsius
06-07	2			Temp Low Warning	-5 degree Celsius
08-09		2		Voltage High Alarm	3.6V	Volt
10-11		2		Voltage Low Alarm	3.0V
12-13		2		Voltage High Warning	3.5V
14-15		2		Voltage Low Warning	3.1V
16-17		2		Bias High Alarm	Iop+10 mA	mA	2
18-19	2		Bias Low Alarm		Iop-5 mA
20-21	2			Bias High Warning	Iop+7 mA
22-23	2			Bias Low Warning	Iop-3 mA
24-25		2		TX Power High Alarm	P +3dB	dBm		3
26-27		2		TX Power Low Alarm	P-3dB
28-29		2		TX Power High Warning	P +2dB
30-31		2		TX Power Low Warning	P-2dB
32-33		2		RX Power High Alarm	0dBm	dBm	4
34-35	2			RX Power Low Alarm	-13.1dBm
36-37	2			RX Power High Warning	-1dBm
38-39	2			RX Power Low Warning	-11.1dBm
40-45		16		Reversed
56-91		36		External Calibration Constants
92-94		3		Reversed
95		1		Checksum				5
96-97		2		Real Time Temperature
98-99	2		Real Time Supply Voltage
100-101	2		Real Time Tx Bias Current
102-103	2		Real Time Tx Optical Power
104-105	2		Real Time Rx Received Power
106-109		4		Reserved
110		1		Optional Status/ Control Bits
111		1		Reserved
112-119		8		Optional Set of Alarm and Warning

Notes:

1)TC: Case Operating temperature

2)IOP: Operating current at room temperature. The min. setting current is 0 mA.

3)P: Operating optical power of transmitter at room temperature.

4)P0: Overload optical power of receiver

PS: Sensitivity optical power of receiver

5) Byte 95 contains the low order 8bits of sum of bytes 0-94

14	Revision: 0B
	2008/9/5
DELTA ELECTRONICS, INC.	www.deltaww.com