Compaq H9A11 manual Installation

Page 14

Installation

_______________________ WARNING __________________________

High Leakage Current --- An insulated earthing conductor that is identical in size, insulation material, and thickness to the earthed and unearthed branch- circuit supply conductors (except that it is green with or without one or more yellow stripes) is to be installed as part of the branch circuit that supplies the unit or system. The earthing conductor described is to be connected to earth at the service equipment or, if supplied by a separately derived system, at the supply transformer or motor-generator set.

The attachment-plug receptacles in the vicinity of the unit or system are all to be of an earthing type, and the earthing conductors serving these receptacles are to be connected to earth at the service equipment.

___________________________________________________________

_______________________ WARNING __________________________

Use sufficient personnel when unloading the cabinet from the pallet or moving the cabinet to a new location. The cabinet weighs 80.74 kg (178 lb) empty, and can weigh up to 420.94 kg (928 lb) fully configured.

___________________________________________________________

For site preparation details concerning the system devices installed or the systems to be installed in the cabinet, refer to the documentation for those systems.

2–2H9A11 Cabinet Installation/Owner's Guide

Image 14
Contents H9A11 Cabinet Installation/Owners Guide June Table of Contents Figures TablesIntended Audience How to Use This GuideOverview Conventions Safety SymbolOrganization Readers Comments ∙ Internet electronic mail reader-comments@digital.comPage Introduction DescriptionIntroduction Specifications Specifications for the H9A11 Cabinet are as follows4H9A11 Cabinet Installation/Owner’s Guide Site Planning IntroductionTools Required Installation Unpacking Unpacking the Cabinet Installation Installing the Ramps Installation Deskidding the Cabinet Installation Procedures Removing and Replacing the Rear Lift-Off Door RemovalRemoving and Replacing the Rear Lift-Off Door Removing and Replacing the Front Filler Pa nels Removing and Replacing the Front Filler Panels Pulling Out and Adjusting the Stabilizer Bar Pulling Out and Adjusting the Stabilizer Bar Removing and Replacing the Power Distribu tion Unit Removing and Replacing the Power Distribution Unit Page Field Replaceable Units FRUs