Compaq H9A11 manual Pulling Out and Adjusting the Stabilizer Bar

Page 26

Installation

2.5.3 Pulling Out and Adjusting the Stabilizer Bar

The stabilizer bar ôpulls straight out from the bottom front of the cabinet öas shown in Figure 2-6. When the stabilizer bar is fully extended, adjust the foot õat the end of the stabilizer bar until it touches the floor.

_______________________ WARNING __________________________

The stabilizer bar must be fully extended before any system is extended out of the cabinet on its slides.

___________________________________________________________

The H9A11 Cabinet can hold various system configurations. The amount of force required to tip or make the cabinet unstable differs with each configuration.

2–14H9A11 Cabinet Installation/Owner's Guide

Image 26
Contents H9A11 Cabinet Installation/Owners Guide June Table of Contents Figures TablesIntended Audience How to Use This GuideOverview Conventions Safety SymbolOrganization Readers Comments ∙ Internet electronic mail reader-comments@digital.comPage Introduction DescriptionIntroduction Specifications Specifications for the H9A11 Cabinet are as follows4H9A11 Cabinet Installation/Owner’s Guide Site Planning IntroductionTools Required Installation Unpacking Unpacking the Cabinet Installation Installing the Ramps Installation Deskidding the Cabinet Installation Procedures Removing and Replacing the Rear Lift-Off Door RemovalRemoving and Replacing the Rear Lift-Off Door Removing and Replacing the Front Filler Pa nels Removing and Replacing the Front Filler Panels Pulling Out and Adjusting the Stabilizer Bar Pulling Out and Adjusting the Stabilizer Bar Removing and Replacing the Power Distribu tion Unit Removing and Replacing the Power Distribution Unit Page Field Replaceable Units FRUs