Compaq H9A11 manual Removing and Replacing the Rear Lift-Off Door, Removal

Page 22

Installation

2.5.1 Removing and Replacing the Rear Lift-Off Door

The rear lift-off door provides access into the rear of the cabinet. To remove the rear lift-off door, refer to Figure 2-4 and proceed as follows:

Removal

1.Remove the two Phillips-head screws ôthat secure the rear lift-off door to the two brackets úat the top rear of the cabinet.

2.Grasp both sides of the rear lift-off door about midway up the door. Then lift the door up until the securing tabs öon the rear lift-off door come out of the tab catches õon the cabinet.

3.Lift the door off and away from the cabinet.

4.Place the rear lift-off door aside and out of the way.

Replacement

To replace the rear lift-off door, reverse the removal procedure, steps 1 through 4.

2–10H9A11 Cabinet Installation/Owner's Guide

Image 22
Contents H9A11 Cabinet Installation/Owners Guide June Table of Contents Figures TablesOverview How to Use This GuideIntended Audience Organization Safety SymbolConventions Readers Comments ∙ Internet electronic mail reader-comments@digital.comPage Introduction DescriptionIntroduction Specifications Specifications for the H9A11 Cabinet are as follows4H9A11 Cabinet Installation/Owner’s Guide Tools Required IntroductionSite Planning Installation Unpacking Unpacking the Cabinet Installation Installing the Ramps Installation Deskidding the Cabinet Installation Procedures Removing and Replacing the Rear Lift-Off Door RemovalRemoving and Replacing the Rear Lift-Off Door Removing and Replacing the Front Filler Pa nels Removing and Replacing the Front Filler Panels Pulling Out and Adjusting the Stabilizer Bar Pulling Out and Adjusting the Stabilizer Bar Removing and Replacing the Power Distribu tion Unit Removing and Replacing the Power Distribution Unit Page Field Replaceable Units FRUs