Compaq H9A11 manual Removing and Replacing the Front Filler Pa nels

Page 24

Installation

2.5.2 Removing and Replacing the Front Filler Pa nels

To remove a front filler panel, refer to Figure 2-5 and proceed as follows:

Removal

Grasp the front filler panel ôon both sides and then pull straight back away from the cabinet.

Replacement

To replace a front filler panel ô, align the sockets öon the front filler panel (refer to the exploded view) with the appropriate ball studs õon the rails úand push the panel into place.

2–12H9A11 Cabinet Installation/Owner's Guide

Image 24
Contents H9A11 Cabinet Installation/Owners Guide June Table of Contents Figures TablesHow to Use This Guide OverviewIntended Audience Safety Symbol OrganizationConventions Readers Comments ∙ Internet electronic mail reader-comments@digital.comPage Introduction DescriptionIntroduction Specifications Specifications for the H9A11 Cabinet are as follows4H9A11 Cabinet Installation/Owner’s Guide Introduction Tools RequiredSite Planning Installation Unpacking Unpacking the Cabinet Installation Installing the Ramps Installation Deskidding the Cabinet Installation Procedures Removing and Replacing the Rear Lift-Off Door RemovalRemoving and Replacing the Rear Lift-Off Door Removing and Replacing the Front Filler Pa nels Removing and Replacing the Front Filler Panels Pulling Out and Adjusting the Stabilizer Bar Pulling Out and Adjusting the Stabilizer Bar Removing and Replacing the Power Distribu tion Unit Removing and Replacing the Power Distribution Unit Page Field Replaceable Units FRUs