APPENDIX
LAMP REPLACEMENT
When the life of the Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When a projected image becomes dark or the color of an image becomes unnatural, replacement of Projection Lamp is required.
|
|
|
|
|
|
|
|
|
|
|
| CAUTION |
|
|
| CAUTION |
|
|
|
| For continued safety, replace with a lamp |
|
|
| Do not drop a lamp assembly or touch a glass |
|
|
|
| assembly of same type. |
|
|
| bulb! The glass can shatter and may cause |
|
|
|
| Allow the projector to cool for at least 45 |
|
|
| injury. |
|
|
|
| minutes before you open Lamp Cover. The |
|
|
|
|
|
|
|
|
|
| ||||
|
|
| inside of the projector can become very hot. |
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Follow these steps to replace lamp assembly.
1 | Turn off a projector and disconnect AC plug. Allow a projector to |
cool for at least 45 minutes. | |
2 | Loosen 2 screws with a screwdriver and open Lamp Cover. |
3 | Loosen 2 screws with a screwdriver and pull out Lamp Assembly |
by grasping Handle. | |
4 | Replace Lamp Assembly with a new one and tighten 2 screws |
back. Make sure that Lamp Assembly is set properly. Replace | |
| Lamp Cover and tighten 2 screws. |
5 | Connect AC Power Cord to a projector and turn it on. |
6 | Reset Lamp Replace Counter (refer to section “Lamp Replace |
Counter” below). |
NOTE : Do not reset Lamp Replace Counter when Projection Lamp is not replaced.
| LAMP COVER |
LAMP | HANDLE |
ASSEMBLY |
|
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give the following information to the dealer.
● Model No. of your projector :
●Replacement Lamp Type No. :
(Service Parts No. 610 297 3891)
LAMP REPLACE COUNTER
Be sure to reset Lamp Replace Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP REPLACE Indicator stops lighting.
1 | Turn projector on, press MENU button and |
| to move the red frame pointer to SETTING Menu icon (refer to page 37). |
2 | Press the POINT DOWN button to move the red frame pointer to “Lamp counter reset” and then press SELECT button. |
| The message "Lamp replace counter reset?" will display. Move pointer to [Yes] and then press SELECT button. |
3 | Another confirmation dialog box will appear and select [Yes] to reset Lamp Replace Counter. |
Do not reset Lamp Replace Counter unless Projection Lamp is replaced.
39