Part Names and Functions
Terminals and Connectors
= |
SERIAL PORT IN TERMINAL
If you control the projector by computer, you must connect a cable (not supplied) from your computer to this terminal.
SERIAL PORT OUT TERMINAL
This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled with one computer by connecting SERIAL PORT IN of another projector to this terminal.
USB CONNECTOR (Series B)
USB connector is to used to service the projector.
R/C JACK
When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied).
;RESET button
!!BUILTIN MICRO PROCESSOR WHICHHCONTROLS THISOUNIT MAYY OCCASIONALLY MALFUNCTION AND NEEDFTO BECRESET 4HISICAN BE DONE BYYPRESSING THE 2%3%44BUTTONOWITH A PENHWHICHHWILL SHUTLDOWN ANDNRESTARTRTHE UNITE $OUNOTIUSETHE 2%3%44FUNCTION EXCESSIVELY
DVI INPUT TERMINAL
Connect computer output
HD (HDCP Compatible) signal can be also connected. (p.21)
D-sub 15-PIN INPUT TERMINAL
Connect computer output (Analog
5 BNC INPUT JACKS
Connect the component or composite video output signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect the computer output signal (5 BNC Type [Green, Blue, Red, Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks.
Connect the
LX1000 User Manual | 11 |
|