Connecting the Projector to a Portable Computer
1.Rotate the elevator foot to balance the projector.
2.Connect one end of the projector signal cable to the projector and the other end to the VGA connector ➊B or the DFP connector ➊A on the portable computer and tighten the screws.
✎Be sure the signal cable aligns with the connector. Do not force the cable onto the connector or you may damage the signal cable or the projector.
3.Connect one end of the power cord ➋ into the back of the projector, and the other end to an electrical outlet that is easily accessible and close to the projector.
4.Turn on the projector first, then turn on the computer. Refer to the “Powering On the Projector” section later in this chapter for instructions on turning on the projector.
✎For security purposes, this projector has been fitted with a security lock slot ➌ (located on the left, front side) for use with a security cable lock that can be purchased separately at most computer stores.
Getting Started |