Computer Input
Keystone
This function is used to store or reset the keystone correction
when the AC power cord is unplugged. Use the Point 7 8 buttons to switch between each option.
Store . Keep the keystone correction even when the AC power cord is unplugged.
Reset . Release the keystone correction when the AC power cord is unplugged.
To correct keystone distortion, press the Select button. The
Keystone dialog box appears. Use the Point ed7 8 buttons to correct keystone distortion. (p.29)
Ceiling
When this function is set to “On,” the picture is top/bottom and left/right reversed. This function is used to project the image from a
Rear
When this function is set to “On,” the picture is left/right reversed. This function is used to project the image from the rear of the screen.
Reset
This function returns all adjusted values to the factory default settings. Press the SELECT button at Reset to display a confirmation box. To reset, press the SELECT button at “Yes.”
Quit
Exit the Screen Size Adjustment Menu.
For zooming in and out the images
Digital zoom +
Select Digital zoom +. The
size. Use the Point ed7 8 buttons to pan the image. The Panning function can work only when the image is larger than the screen size.
You can also enter the Digital zoom + mode by pressing the D.ZOOM button on the remote control.
Digital zoom –
Select Digital zoom
You can also enter the Digital zoom – mode by pressing the D.ZOOM button on the remote control.
To exit the Digital Zoom +/– mode, press any button except the D.ZOOM , SELECT, and Point buttons.
SCREEN MENU
Move the red frame pointer to the desired function and press the SELECT button.
Ceiling |
Rear |
✔Note:
•The panning function may not operate properly if the stored Mode in the PC Adjust Menu is used. (p. 37)
•The minimum compression ratio can be limited depending on the input signal or when the Keystone function is working.
•Digital zoom +/– cannot be selected when Full screen orTrue is selected.
40