Acer S3811 manual Features

Page 8

Features

Operating system

Windows®7 Home Premium x86/x64, Windows® 7 Home Basic x86, Windows®7 Starter x86

Processor

The motherboard uses an LGA1156 type of socket that carries the following

Features:

•Accommodates 2nd Generation IntelR CoreTM Family / PentiumR / CeleronR processors

•Supports “Hyper-Threading” technology CPU

•One PCI Express x16 Gen2 port supporting up to 5 GB/s direction peak bandwidth

“Hyper-Threading” technology enables the operating system into thinking it’s hooked up to two processors, allowing two threads to be run in parallel, both on separate “logical” processors within the same physical processor.

Chipset

The Intel H57 Express Chipset is a single-chip with proven reliability and performance.

•Support one PCI Express slot

•Integrated two SATA 3.0 Gb/s Host Controller

•Fourteen USB 2.0 ports supported

•Serial Peripheral Interface (SPI) support

•Integrated Graphics Support with PAVP 1.5

•• Intel® High Definition Audio Controller

Memory

•Supports DDR3 1333/1066 DDR3 SDRAM with Dual-channel architecture

•Accommodates four unbuffered DIMMs

•Up to 4 GB per DIMM with maximum memory size up to 16 GB

Onboard LAN

The onboard LAN provides the following features:

•Supports PCI ExpressTM 1.1

•Integrated 10/100 /1000 transceiver

•Wake-on-LAN and remote wake-up support

Audio

•5.1 Channel High Definition Audio Codec

•ADCs support 44.1k/48k/96kHz sample rate

•Meets Microsoft WLP 3.10 Vista premium and mobile PCs audio requirements

•Direct Sound 3DTM compatible

Expansion Options

The motherboard comes with the following expansion options:

•One PCI Express x16 slot for Graphics Interface

•One PCI Express x1 slot

•Two SATA connectors

2

Image 8

Contents Imedia S3811 Service Guide Date Chapter Updated Revision HistoryCopyright Conventions Preface Page Introducing the Motherboard IntroductionFeatures Integrated I/O Bios FirmwareDimensions and weight Mainboard Components Label ComponentBlock Diagram Imedia S3811 Icon Component DescriptionRear view 1CH Audio Jack Function TableColor/Use Headphone Port Introduction Component DescriptionSystem Peripherals Mouse PS/2 or USB, manufacturing optionKeyboard PS/2 or USB, manufacturing option SpeakersCard Reader Option Hardware Specifications and Configurations Bios Hotkey ListSpecification Main Board Major ChipsSystem Memory Cache MemoryVideo Interface Audio InterfacePower Management IDE InterfaceUSB Port Devices Idle Shut DownPower Management Function Acpi support function Device Standby ModeGlobal Standby Mode Suspend ModeUsing Bios About the Setup UtilityStandard Configuration Entering the Setup UtilitySetup Utility Menus Updating the Bios Product Information Item HelpStandard Cmos Features Date and TimeA.R.T. Enabled UAHCI Port1 /Port2Sata Port0 Auto Halt On All, But KeyboardQuiet Boot Enabled Advanced Bios FeaturesQuick Boot Enabled Sequence from Available devices Removable Device Priority Press Enter Boot Up NumLock On USB Beep Message DisabledAdvanced Chipset Features Integrated Peripherals Power Management Setup Restore On AC Power Loss Last State Smart Fan Enabled PC Health StatusSpread Spectrum Enabled Frequency/Voltage ControlBios Security Features Load Default SettingsSupervisor Password Not Installed User Password Not InstalledSave & Exit Setup Exit Without SavingMachine Disassembly and Replacement General Information Before You BeginRemoving PSU bracket Standard Assembly ProcessOpening the chassis Removing HDD bracket Removing front bezelInsert the ODD devices Setting the Motherboard Page 1x1G 2x1G3x1G 4x1GAssembly motherboard Insert the system FanPage Front Pulling in HDD &ODD Sata cable on Motherboard Insert VGA card Insert the PSU Long for HDD used Short for ODD used Overview Standard Disassembly Process Removing the power-supplyPage Pulling out the Sata ODD cable and Sata HDD cable Removing the HDDFrontBack Removing the VGA Card Pulling out the Audio/USB1/CR/PANEL cableRemoving system Fan Removing the Main Board Page Release the four latch show bellow then remove the Memory Removing the ODD Removing the ODD bracketRemoving the ODD bracket Pushing the Cable Removing power switch & HDD-LED holder Page Machine Disassembly and Replacement Power-On Self-Test Post KB-5 Initializes DMAC-1 & DMAC-2 Needed Post Error Messages List Bios Messages Action/FRUSpecifics about the type and location of the memory error Error Symptoms List Error Symptom Action/FRU Processor / Processor FanMain board and Memory Hard Disk DriveError Symptom Action/FRU CD/DVD-ROM Drive AudioError Symptom Action/FRU Video and Monitor Power SupplyParallel/Serial Ports KeyboardError Symptom Action/FRU Other ProblemsUndetermined Problems Jumper and Connector Information Safety PrecautionsInstalling the Motherboard in a Case Choosing a Computer CaseChecking Jumper Settings Setting JumpersJumper Type Description Setting Default IIIustration Checking Jumper SettingsJumper Settings Connecting Case Components Connecting 24-pin power cableSysfan Cooling Fan Power Connector Pin Signal Name Function Atxpoweratx 24-pin Power Connector Pin Signal NameATX12V ATX 12V Power Connector Pin Signal Name Pin Signal NamePin Signal Name Function Power/Sleep/Message waiting LEDReset Switch Power SwitchBefore installing the Processor Installing HardwareInstalling the Processor CPU Installation Procedure Following illustration shows CPU installation componentsMemory Memory Bus Installing Memory ModulesInstallation Procedure Installing Serial ATA Hard Drives Sata cable optional Sata power cable optionalInstalling Add-on Cards PCIE1X1 SlotOnboard PCI interface does not support 64-bit Scsi cards Connecting Optional Devices FAUDIO1 Front Panel Audio headerSata 1~4 Serial ATA connectors Spdifo Spdif out headerOptionFRU Field Replaceable Unit List Exploded Diagram ChassisP5-15L w/ card reader ME BOMPage ChassisP5-15L w/o card reader ME BOM Page FRU List