BOXLIGHT CP-12tA manual Remote Control does, Not work, Wireless Mouse, Function does not, Work

APPENDIX

Problem:	Try these Solutions
Remote Control does	● Check the batteries.
not work.	● Check ALL-OFF switch on the Remote Control is set to “ON.”
	● Make sure there is no obstructions between the projector and the Remote Control.
	● Make sure you are not too far from the projector when using the Remote Control.
	Maximum operating range is 16.4’ (5m).
	● Make sure the code of the Remote Control is set to conform to the projector.
	(See the “SETTING” section on page 37.)
Wireless Mouse	● Check cable connection between the projector and your computer.
function does not	● Check the mouse setting on your computer.
	● Turn the projector on before turning on the computer.
work.

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact Boxlight for assistance at 1-800-762-5757 or 360-779-7901. Give the model number and explain about the problem. We will advise you how to obtain service.

Please have the following information available.

●Serial No. of projector.

●Resolution of the computer.

●Refresh rate of computer.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

The CE Mark is a Directive conformity mark of the European Community (EC).

43