BenQ MP727, MP735 user manual Remote control effective range

Remote control effective range

Infra-Red (IR) remote control sensor is located on the front of the projector. The remote control must be held at an angle within 30 degrees perpendicular to the projector's IR remote control sensor to function correctly. The distance between the remote control and the sensor should not exceed 7 meters (~ 23 feet).

Make sure that there are no obstacles between the remote control and the IR sensor on the projector that might obstruct the infra-red beam.

Replacing the remote control battery

1.Remove the battery compartment cover by sliding the cover in the direction of the arrow.

2.Insert the supplied batteries taking note of the polarity (+/-) as shown here.

3.Replace the cover.

English

•Avoid excessive heat and humidity.

•There may be battery damage if the battery is incorrectly replaced.

•Replace only with the same or equivalent type recommended by the battery manufacturer.

•Dispose of the used battery according to the battery manufacturer’s instructions.

•Never throw a battery into a fire. There may be danger of an explosion.

•If the battery is dead or if you will not be using the remote control for a long time, remove the battery to prevent damage to the remote control from possible battery leakage.

Introduction 13