If you are in a non-DHCP environment:
1.Repeat steps
2.Press 
to highlight DHCP and press 
/ 
to select Off.
3.Contact your ITS administrator for information on the Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings.
4.Press 
to select the item you want to modify.
5.Press 
/ 
to move the cursor and the press 
/ 
to enter the value.
6.Press 
to highlight Apply and press Mode/Enter.
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby mode, you can use any computer that is on the same local area network to control the projector.
1.Enter the address of the projector in the address bar of your browser and click GO.
2.The remote network operation page opens. This page allows you to operate the projector as if you were using the remote control or control panel on the projector.
i
ii | i |
|
i
i.These buttons function the same as the ones on the OSD menus or remote control. See "2. PICTURE menu" on page 48 and "Remote control" on page 11 for details.
The Menu button can also be used to go back to previous OSD menu, exit and save menu settings.
ii. To switch input source, click on your desired signal.