BenQ MP776 ST user manual Adjusting the projected image, Adjusting the projection angle

signal which is compatible with the projector's resolution or set the input signal to a lower setting. See "Timing chart" on page 63 for details.

Adjusting the projected image

Adjusting the projection angle

The projector is equipped with 1 quick-release adjuster foot and 1 rear adjuster foot. These adjusters change the image height and projection angle. To adjust the projector:

1.Press the quick-release button and lift the front

of the projector. Once the image is positioned where you want it, release the quick-release button to lock the foot in position.

2. Screw the rear adjuster foot to fine-tune the horizontal angle.

To retract the foot, hold up the projector while	2	1
pressing the quick-release button, then slowly lower
the projector. Screw the rear adjuster foot in a reverse		Do not look into the lens while
direction.
		the lamp is on. The strong light
If the projector is not placed on a flat surface or the		from the lamp may cause
screen and the projector are not perpendicular to each		damage to your eyes.
other, the projected image becomes trapezoidal. To		Be careful when you press the
correct this situation, see "Correcting keystone" on		quick-release button as it is
page 28 for details.		close to the exhaust vent where
		hot air comes from.

Auto-adjusting the image

In some cases, you may need to optimize the picture quality. To do this, press AUTO on the projector or remote control. Within 3 seconds, the built-in Intelligent Auto Adjustment function will re-adjust the values of Frequency and Clock to provide the best picture quality.

The current source information will be displayed in the corner of the screen for 3 seconds.

• The screen will be blank while AUTO is functioning.

•This function is only available when PC signal (analog RGB) is selected.

Fine-tuning the image clarity

If needed, sharpen the image by rotating the focus ring.

24 Operation