BenQ W6000 Selecting an input source, Fine-tuning the image size and clarity, Using the OSD menu

Selecting an input source

The projector can be connected to multiple equipment at the same time. When the projector is first turned on, it will attempt to reconnect with the input source which was in use when the projector was last shut down.

To select the video source:

•Using the remote control or projector

Press one of the Source keys on the remote control, or press SOURCE on the projector repeatedly until your desired signal is selected.

•Using the OSD menu

1.Press MENU and then press / until the System Setup menu is highlighted.

2.Press to highlight Input Source and press ENTER. The source selection bar displays.

3.Press / repeatedly until your desired signal is selected and press

ENTER.

Once detected, the selected source information will display on the screen for seconds. If there are multiple pieces of equipment connected to the projector, you can go back to the source selection bar again to search for other signals.

•If you want the projector to automatically search for the signals, select On in the System Setup > Auto Source Search menu.

•If you want to use the PIP function, see "Displaying more than one image source simultaneously" on page 35 for details.

System Setup

Language	English
Splash Screen	BenQ
Projector Position	Floor Front
Auto Off	Disable
Sleep Timer	Disable
Background Color	Blue
Menu Settings
Input Source	ENTER
Auto Source Search	On
S-Video	EXIT Back
	NOTE: When
	automatically
	searching for a
	valid input
	source, the
	projector cycles
	through the
	available signals
	following the
	sequence from
	top to bottom as
	the source
	selection bar
	shows.

English

Fine-tuning the image size and clarity

1. Adjust the projected picture to the size that	2. Sharpen the picture by rotating the focus
you need using the zoom ring.	ring.

Using the projector 21