Controlling the projector through a LAN environment
Network Settings allow you to manage the projector from a computer using a web browser when the computer and the projector are properly connected to the same local area network.
Configuring the Wired LAN Settings
Internet
IP Router
If you are in a DHCP environment:
1.Take a RJ45 cable and connect one end to the LAN input jack of the projector and the other end to the RJ45 port.
2.Press MENU/EXIT and then press 
/ 
until the SYSTEM SETUP: Advanced menu is highlighted.
3.Press 
to highlight Network Settings and press MODE/ENTER. The Network Settings page displays.
4.Press 
to highlight Wired LAN and press MODE/ENTER.
5.Press 
to highlight DHCP and press 
/ 
to select On.
6.Press 
to highlight Apply and press MODE/ENTER.
7.
If the IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
1.Repeat steps
2.Press 
to highlight DHCP and press 
/ 
to select Off.
3.Contact your ITS administrator for information on the IP Address, Subnet Mask, Default Gateway, and DNS Server settings.
4.Press 
to select the item you want to modify and enter the value.
5.Press 
to highlight Apply and press MODE/ENTER.
Configuring the Wireless LAN Settings
BenQ wireless dongle